噴油泵試驗臺功能介紹：

噴油泵試驗臺根據所調試的油泵，選用適當的附具，可進行如下項目的調試：

1測試不同轉速下噴油泵的各缸供油量和供油均勻性。

2測試噴油泵的供油始點及供油間隔角度。

3調速器工作性能的檢查及調整。

4壓力補償性能的測試及檢查。

5分配泵工作性能的測試及調整。

6冷啟動裝置及電磁閥性能檢查。

7分配泵各種轉速下的回油量測量。

8分配泵各種轉速下的內壓測定。

9噴油泵密封性能實驗。

10檢查輸油泵自吸功能。

11內置高可靠性臥式打氣泵。

12三“T”型工作臺、寬體定位支架，設備運轉穩定 油泵試驗臺生產廠家 一三八五四八二二三九五12PSB系列噴油泵實驗試驗臺生產基地

※ 采用工業計算機標準，可靠性高

※ 按照“人機工程學”原則設計，布局合理，使用方便

※ 強電系統采用SSR固態繼電器無觸點控制，安全可靠

※ 上位機采用電子盤和DOS平臺，抗震、耐沖擊

※ 壓力、溫度、提前角等參數均為屏幕數顯

The purpose of the pump test-bed

The oil pump of pump test-bed based on the debugging and selection of appropriate affix, debugging for the following projects:

1 testing the fuel injection pump under different rotation speed of each cylinder oil and oil supply uniformity.

2 test of the fuel injection pump fuel supply starting point and interval Angle oil.

3 speed governor and adjust the working performance of the inspection.

4 pressure compensation performance test and check.

5 distribution pump performance test and adjustment.

6 cold start device and electromagnetic valve performance examination.

7 allocated amount of oil pump under different rotation speed measurement.

8 distribution of internal pressure measurement of the pump under different rotation speed.

9 for fuel pump seal performance experiment.

10 check oil transfer pump self-priming function.

11 the built-in high reliability horizontal pump.

12 three "T" type workbench, wide-bodied positioning support, equipment operation stability

※